How do I install the Local Exhaust accessory?

To install the Local Exhaust, remove the right side access panel using the 2.5mm hex driver. Remove the three hole-plugs on the top panel and place the Local Exhaust on top of the instrument. Two locating pins on the exhaust will match the holes in the top panel. Secure the exhaust using the provided thumb screw. Insert the screw from inside the instrument through the top panel hole and tighten it.

Connect the local exhaust to the instrument using the cable provided. It should be connected to the accessories power port on the back side of the instrument (see “Interface Ports” page 25).

Open the Local Exhaust cover by loosening the two thumb screws and make sure that the pre filter is correctly inserted as it may have shifted during shipment. Replace the cover and re-secure.

Your Local exhaust is now ready.