100X Startup Sequence

Initializing Sensors

Waiting on Air

Check Level - Press Continue

Allow for Warmup.

Select an Operator and enter PIN.

Place test filter on chuck and press Start to begin Gravimetric Calibration.

*Close chuck by placing fingers in the actuators on the left and right of the 100X unit.

When calibration is finished, remove filter from chuck and weigh on a scale.

Enter in weight in Final Filter Mass category.

Press Accept to continue.

Press Begin to start LSC Calibration.

Close chuck.

When calibration is finished, press Accept to continue or Reject to restart calibration.

Press Begin to start Penetration Calibration.

When calibration is complete, press Accept.
Main Menu will appear. 100X unit is calibrated and ready for filter testing.